If you've enabled debugging, issued a term mon command and are still not seeing any debugging output, then the logging level for the monitor (what you're asking to be showing when you issue term mon) may be set to a lower level than debug.
You can see what logging levels are set by using the show log command. Look for the Console logging: and Monitor logging: lines. If it does not say level debugging then you wont see any debug output for that output type.
To enable debug level output for the monitor, type:
Router(config)#logging monitor debug
The just enter
Router#term mon
and you should start seeing the debugging output (assuming you have turned debugging on for something!)
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment